Cat Arctic Platinum Grease For use in extremely cold environments.
NLGI Grade 0 Recommended Use
Cat Arctic Platinum Grease is recommended for grease fittings and lubrication points in all load and speed applications and ambient temperature ranges of -50° to 20°C (-58° to 68°F). Discover the Difference
Cat Arctic Platinum Grease is developed, tested and approved by Caterpillar to meet the same high standards as Genuine Cat Parts.
Extreme Life—High-quality calcium-sulfonate complex synthetic base with 5% molybdenum disulfide (moly) delivers unmatched performance in Cat applications.
Extreme-Cold Operation—Performs and protects where ambient temperatures are regularly below 0°F.
Moisture Resistance—Resists washout from fresh and salt water.
Reduced Component Wear—Resists softening and continues to protect parts under extreme loads and high speeds.
Corrosion Protection—Resists oxidation and protects metal against rust. Will not corrode or damage steel, copper bearing alloys or conventional seal materials.
Low Environmental Risk—Is formulated not to contain lead, antimony, zinc, barium, chlorine, phosphorus or free sulfur.
Caterpillar. The difference counts. ™
Cat Dealers define world-class product support. We offer you the right parts and service solutions, when and where you need them.
The Cat Dealer network of highly trained experts keeps your entire fleet up and running to maximize your equipment investment.
Typical Characteristics |
NLGI# |
0 |
Ambient Range, F |
-58° to +68° |
Ambient Range, C |
-50° to +20° |
Operating Range, F |
-70° to +275° |
Operating Range, C |
-57° to +135° |
Base Fluid Type |
Synthetic |
Thickener Type |
Calcium Sulfonate Complex |
Color |
Platinum |
% Molybdenum disulfide |
5 |
Worked Penetration (mm) |
355-385 |
% Change/100,000 stroke |
+/-5 |
Roll Stability w/H2O, % change |
+/-5 |
Viscosity Index, Min |
125 |
Viscosity @ 100°C, cSt |
5-7 |
Viscosity @ 40°C, cSt |
30-40 |
4 Ball Wear (mm) Max, Typ. |
0.45 |
4 Ball E.P. Weld Point (kg) Typ. |
620 |
Timken E.P. Test OK load (lb) Typ. |
65 |
Oxidation-psi drop/500 hr Max |
5 |
Rust Test |
Pass |
Salt Fog Test, hours |
N/A |
Copper Corrosion |
1a |
Dropping Point |
+260°C (+500°F) |
*The values shown are typical values and should not be used as quality control parameters to either accept or reject product. Specifications are subject to change without notice.
Other Recommended Greases
Cat Ultra 5Moly Grease
For high-load and high-speed conditions in moderate-temperature environments.
Cat Desert Gold™ Grease
For extremely hot temperatures up to 60°C(140°F).
Health and Safety
For information on proper use for health, safety, and environment, please refer to the Material Safety Data Sheet (MSDS). Read and understand the MSDS before using this product. Always observe good hygiene measures.
Вернуться к списку
|